Airworthiness Directives; British Aerospace (Jetstream) Model 4101 Airplanes
Requires manufacture and installation of a placard on the left- hand instrument panel in the cockpit to prohibit push-backs of the airplane while the engines are running.
[Federal Register Volume 65, Number 23 (Thursday, February 3, 2000)]
[Rules and Regulations]
[Pages 5228-5229]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 00-2088]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 99-NM-309-AD; Amendment 39-11539; AD 2000-02-21]
RIN 2120-AA64
Airworthiness Directives; British Aerospace (Jetstream) Model
4101 Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment adopts a new airworthiness directive (AD),
applicable to all British Aerospace (Jetstream) Model 4101 airplanes,
that requires manufacture and installation of a placard on the left-
hand instrument panel in the cockpit to prohibit push-backs of the
airplane while the engines are running. In lieu of accomplishing the
placard installation, this amendment requires repetitive installation
of a new tow bracket sub-assembly that has the serial number and date
of installation vibro etched on it. This amendment is prompted by
issuance of mandatory continuing airworthiness information by a foreign
civil airworthiness authority. The actions specified by this AD are
intended to prevent fatigue failure of the towing bracket. Failure of
the towing bracket could cause a towing vehicle to collide into the
propeller while the airplane engines are running, and consequently,
cause damage to the airplane, and injure ground personnel, flight crew,
or passengers.
DATES: Effective March 9, 2000.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of March 9, 2000.
ADDRESSES: The service information referenced in this AD may be
obtained from British Aerospace Regional Aircraft American Support,
13850 Mclearen Road, Herndon, Virginia 20171. This information may be
examined at the Federal Aviation Administration (FAA), Transport
Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton,
Washington; or at the Office of the Federal Register, 800 North Capitol
Street, NW., suite 700, Washington, DC.
FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager,
International Branch, ANM-116, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425)
227-2110; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal
Aviation Regulations (14 CFR part 39) to include an airworthiness
directive (AD) that is applicable to all British Aerospace (Jetstream)
Model 4101 airplanes was published in the Federal Register on November
24, 1999 (64 FR 66121). That action proposed to require manufacture and
installation of a placard on the left-hand instrument panel in the
cockpit to prohibit push-backs of the airplane while the engines are
running. In lieu of accomplishing the placard installation, the action
proposed to require repetitive installation of a new tow bracket sub-
assembly that has the serial number and date of installation vibro
etched on it.
Comments
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were submitted in response
to the proposal or the FAA's determination of the cost to the public.
Change Made to the Final Rule
Paragraph (b) of the final rule has been changed to correct the
citation of Jetstream Service Bulletin J41-32-070, Revision 1, dated
September 14, 1999. ``Revision 1'' was inadvertently omitted in the
citation.
Conclusion
After careful review of the available data, the FAA has determined
that air safety and the public interest require the adoption of the
rule with the change described previously. The FAA has determined that
this change will neither increase the economic burden on any operator
nor increase the scope of the AD.
Cost Impact
The FAA estimates that 59 airplanes of U.S. registry will be
affected by this AD.
It will take approximately 1 work hour per airplane to accomplish
the required placard installation, at an average labor rate of $60 per
work hour. Based on these figures, the cost impact of the placard
installation required by this AD on U.S. operators is estimated to be
$3,540, or $60 per airplane.
The cost impact figure discussed above is based on assumptions that
no operator has yet accomplished any of the requirements of this AD
action, and that no operator would accomplish those actions in the
future if this AD were not adopted.
Should an operator elect to accomplish the optional action that is
provided by this AD action, it will take approximately 2 work hours per
airplane to accomplish it, at an average labor rate of $60 per work
hour. The cost of required parts will be approximately $733 per
airplane. Based on these figures, the cost impact of the optional
action will be $853 per airplane, per replacement cycle.
Regulatory Impact
The regulations adopted herein will not have a substantial direct
effect on the States, on the relationship between the national
Government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, it
is determined that this final rule does not have federalism
implications under Executive Order 13132.
For the reasons discussed above, I certify that this action: (1) Is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic impact, positive or negative, on a substantial
number of small entities under the criteria of the Regulatory
Flexibility Act. A final evaluation has been prepared for this action
and it is contained in the Rules Docket. A copy of it may be obtained
from the Rules Docket at the location provided under the caption
ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
[[Page 5229]]
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new
airworthiness directive:
2000-02-21 British Aerospace Regional Aircraft [Formerly Jetstream
Aircraft Limited; British Aerospace (Commercial Aircraft) Limited]:
Amendment 39-11539. Docket 99-NM-309-AD.
Applicability: All Model Jetstream 4101 airplanes, certificated
in any category.
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (c) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required as indicated, unless accomplished
previously.
To prevent fatigue failure of the towing bracket, which could
cause a towing vehicle to collide into the propeller while the
airplane engines are running, and consequently, could cause damage
to the airplane, and injure ground personnel, flight crew, or
passengers, accomplish the following:
Placard Installation
(a) Prior to the accumulation of 12,000 total landings on the
shock strut of the nose landing gear (NLG), or within 5 days after
the effective date of this AD, whichever occurs later: Except as
provided by paragraph (b) of this AD, manufacture and install a
placard on the left-hand instrument panel in the cockpit to prohibit
push-backs with engines running, in accordance with Jetstream Alert
Service Bulletin J41-11-024, dated May 11, 1999.
Repetitive Action
(b) In lieu of accomplishing the actions specified in paragraph
(a) of this AD, at the time specified in paragraph (a) of this AD,
vibro etch the serial number and date of installation on a new tow
bracket sub-assembly; and install the new tow bracket sub-assembly,
in accordance with Jetstream Service Bulletin J41-32-070, Revision
1, dated September 14, 1999. Repeat the vibro etch process and
installation of a new sub-assembly thereafter at intervals not to
exceed 12,000 landings on the shock strut of the NLG.
Alternative Methods of Compliance
(c) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, International Branch, ANM-116, FAA,
Transport Airplane Directorate. Operators shall submit their
requests through an appropriate FAA Principal Maintenance Inspector,
who may add comments and then send it to the Manager, International
Branch, ANM-116.
Note 2: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the International Branch, ANM-116.
Special Flight Permits
(d) Special flight permits may be issued in accordance with
Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR
21.197 and 21.199) to operate the airplane to a location where the
requirements of this AD can be accomplished.
Incorporation by Reference
(e) The actions shall be done in accordance with Jetstream Alert
Service Bulletin J41-11-024, dated May 11, 1999; or Jetstream
Service Bulletin J41-32-070, Revision 1, dated September 14, 1999;
as applicable. This incorporation by reference was approved by the
Director of the Federal Register in accordance with 5 U.S.C. 552(a)
and 1 CFR part 51. Copies may be obtained from British Aerospace
Regional Aircraft American Support, 13850 Mclearen Road, Herndon,
Virginia 20171. Copies may be inspected at the FAA, Transport
Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or
at the Office of the Federal Register, 800 North Capitol Street,
NW., suite 700, Washington, DC.
Note 3: The subject of this AD is addressed in British
airworthiness directive 004-05-99.
(f) This amendment becomes effective on March 9, 2000.
Issued in Renton, Washington, on January 24, 2000.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 00-2088 Filed 2-2-00; 8:45 am]
BILLING CODE 4910-13-P
Sources. Section 1 is written by AircraftDirectives from the record below and is a reading aid only. Section 2 is the United States Government's own text, reproduced without edit.
Federal Register: https://www.federalregister.gov/documents/2000/02/03/00-2088/airworthiness-directives-british-aerospace-jetstream-model-4101-airplanes
Official PDF: https://www.govinfo.gov/content/pkg/FR-2000-02-03/pdf/00-2088.pdf
Packet generated 2026-08-18 08:13 UTC.
This packet is not an airworthiness determination and not legal or maintenance advice. AircraftDirectives reproduces official records and condenses their wording for easier reading. It does not decide, certify or imply whether any aircraft, engine, appliance or part is airworthy, compliant, affected by this directive, or eligible for return to service. No inspection, approval, or determination of any kind is performed or implied by this document.
Section 1 is a reading aid, not the rule. It is our own plain-language condensation, written to help a reader find the relevant directive quickly. It is NOT a substitute for the regulation, it may omit conditions, exceptions, compliance times, alternative methods of compliance (AMOCs) and applicability limits, and it has no legal force whatsoever. Only the official text governs. Where Section 1 and Section 2 differ in any respect, Section 2 - and the official source it was retrieved from - controls absolutely.
Responsibility remains with the owner/operator. Under 14 CFR §91.403 and §91.417 the owner or operator is responsible for maintaining airworthiness and for required records; under §39.7 no person may operate a product to which an airworthiness directive applies except in accordance with that directive. Determining applicability to a specific serial number and configuration, and performing or supervising any required action, is the responsibility of the owner/operator and appropriately certificated personnel.
Accuracy and currency. Section 2 was retrieved at the time stamped above and is reproduced without edit; Federal Register material is a work of the United States Government. Directives are amended, corrected and superseded over time, and this sheet is a snapshot, not a live record - it does not update after printing. Re-check the official sources before acting on it. This packet is provided without warranty of any kind, express or implied, including fitness for a particular purpose. We do not sell parts and have no commercial interest in any action a directive may require.