Airworthiness Directives; Bell Helicopter Textron Canada Model 430 Helicopters
Requires calibration of the fuel quantity indicating system.
[Federal Register Volume 65, Number 216 (Tuesday, November 7, 2000)]
[Rules and Regulations]
[Pages 66617-66618]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 00-28235]
[[Page 66617]]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 2000-SW-1-AD-1; Amendment 39-11959; AD 2000-22-13]
RIN 2120-AA64
Airworthiness Directives; Bell Helicopter Textron Canada Model
430 Helicopters
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment adopts a new airworthiness directive (AD) for
Bell Helicopter Textron Canada (BHTC) Model 430 helicopters that
requires calibration of the fuel quantity indicating system. This
amendment is prompted by an operator report of an inaccurate fuel
quantity indicating system. The actions specified by this AD are
intended to prevent an inaccurate fuel quantity indicating system
reading, engine flameout due to fuel starvation, and a subsequent
forced landing.
DATES: Effective December 12, 2000.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of December 12, 2000.
ADDRESSES: The service information referenced in this AD may be
obtained from Bell Helicopter Textron Canada, 12,800 Rue de l'Avenir,
Mirabel, Quebec JON1LO, telephone (450) 437-2862 or (800) 363-8023, fax
(450) 433-0272. This information may be examined at the FAA, Office of
the Regional Counsel, Southwest Region, 2601 Meacham Blvd., Room 663,
Fort Worth, Texas; or at the Office of the Federal Register, 800 North
Capitol Street, NW., suite 700, Washington, DC.
FOR FURTHER INFORMATION CONTACT: Paul Madej, Aviation Safety Engineer,
FAA, Rotorcraft Directorate, Standards Staff, Fort Worth, Texas 76193-
0110, telephone (817) 222-5125, fax (817) 222-5961.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal
Aviation Regulations (14 CFR part 39) to include an AD for BHTC Model
430 helicopters was published in the Federal Register on August 9, 2000
(65 FR 48643). That action proposed to require calibration of the fuel
quantity indicating system.
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were received on the
proposal or the FAA's determination of the cost to the public. The FAA
has determined that air safety and the public interest require the
adoption of the rule as proposed.
The FAA estimates that 50 helicopters of U.S. registry will be
affected by this AD, that it will take approximately 2 work hours per
helicopter to accomplish the required actions, and that the average
labor rate is $60 per work hour. Based on these figures, the total cost
impact of the AD on U.S. operators is estimated to be $6,000.
The regulations adopted herein will not have a substantial direct
effect on the States, on the relationship between the national
Government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, it
is determined that this final rule does not have federalism
implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic impact, positive or negative, on a substantial
number of small entities under the criteria of the Regulatory
Flexibility Act. A final evaluation has been prepared for this action
and it is contained in the Rules Docket. A copy of it may be obtained
from the Rules Docket at the location provided under the caption
ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding a new airworthiness directive
to read as follows:
2000-22-13 Bell Helicopter Textron Canada: Amendment 39-11959.
Docket No. 2000-SW-11-AD.
Applicability: Model 430 helicopters, serial numbers 49001
through 49059, certificated in any category.
Note 1: This AD applies to each helicopter identified in the
preceding applicability provision, regardless of whether it has been
otherwise modified, altered, or repaired in the area subject to the
requirements of this AD. For helicopters that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (c) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required at the next scheduled fuel system
calibration or at the next annual inspection, whichever occurs
first, unless accomplished previously.
To prevent an inaccurate fuel quantity indicating system
reading, engine flameout due to fuel starvation, and a subsequent
forced landing, accomplish the following:
(a) Calibrate the fuel quantity indicating system in accordance
with steps 1 through 21 of the Accomplishment Instructions, Bell
Helicopter Textron Alert Service Bulletin No. 430-99-13, dated
December 13, 1999 (ASB).
(b) Insert BHT-430-MM-10, Chapter 95, Revision 2, dated December
10, 1999, into the Maintenance Manual.
(c) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, Regulations Group, Rotorcraft
Directorate, FAA. Operators shall submit their requests through an
FAA Principal Maintenance Inspector, who may concur or comment and
then send it to the Manager, Regulations Group.
Note 2: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the Regulations Group.
(d) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the helicopter to a location where
the requirements of this AD can be accomplished.
(e) Calibrate the fuel quantity indicating system in accordance
with steps 1 through 21 of the Accomplishment Instructions, Bell
Helicopter Textron Alert Service Bulletin No. 430-99-13, dated
December 13, 1999. This incorporation by reference was approved by
the Director of the Federal Register in accordance with 5 U.S.C.
552(a) and 1 CFR part 51. Copies may be obtained from Bell
Helicopter Textron Canada, 12,800 Rue de l'Avenir, Mirabel, Quebec
JON1LO, telephone (450) 437-2862 or (800) 363-8023, fax (450) 433-
0272. Copies may be inspected at the FAA, Office of the Regional
Counsel, Southwest Region, 2601 Meacham Blvd., Room 663, Fort Worth,
Texas; or at the Office of the Federal Register, 800 North Capitol
Street, NW., suite 700, Washington, DC.
(f) This amendment becomes effective on December 12, 2000.
[[Page 66618]]
Note 3: The subject of this AD is addressed in Transport Canada
(Canada) AD No. CF-2000-04, dated February 8, 2000.
Issued in Fort Worth, Texas, on October 27, 2000.
Henry A. Armstrong,
Manager, Rotorcraft Directorate, Aircraft Certification Service.
[FR Doc. 00-28235 Filed 11-6-00; 8:45 am]
BILLING CODE 4910-13-U
Sources. Section 1 is written by AircraftDirectives from the record below and is a reading aid only. Section 2 is the United States Government's own text, reproduced without edit.
Federal Register: https://www.federalregister.gov/documents/2000/11/07/00-28235/airworthiness-directives-bell-helicopter-textron-canada-model-430-helicopters
Official PDF: https://www.govinfo.gov/content/pkg/FR-2000-11-07/pdf/00-28235.pdf
Packet generated 2026-08-18 08:15 UTC.
This packet is not an airworthiness determination and not legal or maintenance advice. AircraftDirectives reproduces official records and condenses their wording for easier reading. It does not decide, certify or imply whether any aircraft, engine, appliance or part is airworthy, compliant, affected by this directive, or eligible for return to service. No inspection, approval, or determination of any kind is performed or implied by this document.
Section 1 is a reading aid, not the rule. It is our own plain-language condensation, written to help a reader find the relevant directive quickly. It is NOT a substitute for the regulation, it may omit conditions, exceptions, compliance times, alternative methods of compliance (AMOCs) and applicability limits, and it has no legal force whatsoever. Only the official text governs. Where Section 1 and Section 2 differ in any respect, Section 2 - and the official source it was retrieved from - controls absolutely.
Responsibility remains with the owner/operator. Under 14 CFR §91.403 and §91.417 the owner or operator is responsible for maintaining airworthiness and for required records; under §39.7 no person may operate a product to which an airworthiness directive applies except in accordance with that directive. Determining applicability to a specific serial number and configuration, and performing or supervising any required action, is the responsibility of the owner/operator and appropriately certificated personnel.
Accuracy and currency. Section 2 was retrieved at the time stamped above and is reproduced without edit; Federal Register material is a work of the United States Government. Directives are amended, corrected and superseded over time, and this sheet is a snapshot, not a live record - it does not update after printing. Re-check the official sources before acting on it. This packet is provided without warranty of any kind, express or implied, including fitness for a particular purpose. We do not sell parts and have no commercial interest in any action a directive may require.