AircraftDirectives
aircraftdirectives.com · Operated by Aircraft Directives 2026
Airworthiness Directive packet

AD 2000-26-08

Airworthiness Directives; British Aerospace (Jetstream) Model 4101 Airplanes

1 · Quick read — prepared by AircraftDirectives

Our plain-language summary — not the regulation

Requires revising the Airworthiness Limitations Section of the Instructions for Continued Airworthiness to incorporate life limits for certain items and inspections to detect fatigue cracking in certain structures.

AD number
2000-26-08
Federal Register document
01-30
Citation
66 FR 264
Amendment
39-12058
Docket
Docket No. 99-NM-250-AD
Action
Final rule.
Published
2001-01-03
Effective
2001-02-07
Effective (as stated in the rule)
Effective February 7, 2001.
Issued by
Transportation Department, Federal Aviation Administration
Regulation
14 CFR 39
Applies to (in our index)
British Aerospace Jetstream 41

2 · Official Federal Register document — government source, verbatim

Reproduced unedited from the Federal Register
[Federal Register Volume 66, Number 2 (Wednesday, January 3, 2001)]
[Rules and Regulations]
[Pages 264-265]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 01-30]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 99-NM-250-AD; Amendment 39-12058; AD 2000-26-08]
RIN 2120-AA64


Airworthiness Directives; British Aerospace (Jetstream) Model 
4101 Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to all British Aerospace (Jetstream) Model 4101 airplanes, 
that requires revising the Airworthiness Limitations Section of the 
Instructions for Continued Airworthiness to incorporate life limits for 
certain items and inspections to detect fatigue cracking in certain 
structures. This amendment is prompted by issuance of a revision to the 
airworthiness limitations of the British Aerospace J41 Aircraft 
Maintenance Manual. The actions specified by this AD are intended to 
ensure that fatigue cracking of certain structural elements is detected 
and corrected; such fatigue cracking could adversely affect the 
structural integrity of these airplanes.

DATES: Effective February 7, 2001.

ADDRESSES: Information pertaining to this amendment may be obtained 
from British Aerospace Regional Aircraft American Support, 13850 
Mclearen Road, Herndon, Virginia 20171. This information may be 
examined at the Federal Aviation Administration (FAA), Transport 
Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, 
Washington.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to all British Aerospace (Jetstream) 
Model 4101 airplanes was published in the Federal Register on October 
20, 2000 (65 FR 63023). That action proposed to require revising the 
Airworthiness Limitations Section of the Instructions for Continued 
Airworthiness to incorporate life limits for certain items and 
inspections to detect fatigue cracking in certain structures.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 59 airplanes of U.S. registry will be 
affected by this AD, that it will take approximately 1 work hour per 
airplane to accomplish

[[Page 265]]

the proposed actions, and that the average labor rate is $60 per work 
hour. Based on these figures, the cost impact of the AD on U.S. 
operators is estimated to be $3,540, or $60 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted. The cost impact figures discussed 
in AD rulemaking actions represent only the time necessary to perform 
the specific actions actually required by the AD. These figures 
typically do not include incidental costs, such as the time required to 
gain access and close up, planning time, or time necessitated by other 
administrative actions.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

2000-26-08  British Aerospace Regional Aircraft [Formerly Jetstream 
Aircraft Limited; British Aerospace (Commercial Aircraft) Limited]: 
Amendment 39-12058. Docket 99-NM-250-AD.
    Applicability: All Model Jetstream 4101 airplanes, certificated 
in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (c) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To ensure continued structural integrity of these airplanes, 
accomplish the following:

Airworthiness Limitations Revision

    (a) Within 30 days after the effective date of this AD, revise 
the Airworthiness Limitations Section (ALS) of the Instructions for 
Continued Airworthiness by incorporating Section 05-10-10, 
``Airworthiness Limitations Description and Operation,'' dated July 
15, 1999, of the British Aerospace J41 Aircraft Maintenance Manual 
(AMM) into the ALS.
    (b) Except as provided by paragraph (c) of this AD: After the 
actions specified in paragraph (a) of this AD have been 
accomplished, no alternative inspections or inspection intervals may 
be approved for the structural elements specified in the document 
listed in paragraph (a) of this AD.

Alternative Methods of Compliance

    (c) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

Special Flight Permits

    (d) Special flight permits may be issued in accordance with 
Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 
21.197 and 21.199) to operate the airplane to a location where the 
requirements of this AD can be accomplished.

Effective Date

    (e) This amendment becomes effective on February 7, 2001.

    Issued in Renton, Washington, on December 22, 2000.
John J. Hickey,
Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 01-30 Filed 1-2-01; 8:45 am]
BILLING CODE 4910-13-U

Sources. Section 1 is written by AircraftDirectives from the record below and is a reading aid only. Section 2 is the United States Government's own text, reproduced without edit.

Federal Register: https://www.federalregister.gov/documents/2001/01/03/01-30/airworthiness-directives-british-aerospace-jetstream-model-4101-airplanes

Official PDF: https://www.govinfo.gov/content/pkg/FR-2001-01-03/pdf/01-30.pdf

Packet generated 2026-08-18 08:13 UTC.

This packet is not an airworthiness determination and not legal or maintenance advice. AircraftDirectives reproduces official records and condenses their wording for easier reading. It does not decide, certify or imply whether any aircraft, engine, appliance or part is airworthy, compliant, affected by this directive, or eligible for return to service. No inspection, approval, or determination of any kind is performed or implied by this document.

Section 1 is a reading aid, not the rule. It is our own plain-language condensation, written to help a reader find the relevant directive quickly. It is NOT a substitute for the regulation, it may omit conditions, exceptions, compliance times, alternative methods of compliance (AMOCs) and applicability limits, and it has no legal force whatsoever. Only the official text governs. Where Section 1 and Section 2 differ in any respect, Section 2 - and the official source it was retrieved from - controls absolutely.

Responsibility remains with the owner/operator. Under 14 CFR §91.403 and §91.417 the owner or operator is responsible for maintaining airworthiness and for required records; under §39.7 no person may operate a product to which an airworthiness directive applies except in accordance with that directive. Determining applicability to a specific serial number and configuration, and performing or supervising any required action, is the responsibility of the owner/operator and appropriately certificated personnel.

Accuracy and currency. Section 2 was retrieved at the time stamped above and is reproduced without edit; Federal Register material is a work of the United States Government. Directives are amended, corrected and superseded over time, and this sheet is a snapshot, not a live record - it does not update after printing. Re-check the official sources before acting on it. This packet is provided without warranty of any kind, express or implied, including fitness for a particular purpose. We do not sell parts and have no commercial interest in any action a directive may require.

AircraftDirectives · AD 2000-26-08 · Section 1 is our plain-language reading aid; Section 2 is the official Federal Register text and controls where the two differ. Not an airworthiness determination — 14 CFR §91.403 / §91.417 responsibility remains with the owner/operator. Retrieved 2026-08-18 08:13 UTC.