Airworthiness Directives; Bell Helicopter Textron Canada Model 222, 222B, 222U, 230 and 430 Helicopters
Requires rewiring and testing the fuel valve switch on each engine and testing the ignitor system.
[Federal Register Volume 73, Number 133 (Thursday, July 10, 2008)]
[Rules and Regulations]
[Pages 39569-39570]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: E8-14718]
========================================================================
Rules and Regulations
Federal Register
________________________________________________________________________
This section of the FEDERAL REGISTER contains regulatory documents
having general applicability and legal effect, most of which are keyed
to and codified in the Code of Federal Regulations, which is published
under 50 titles pursuant to 44 U.S.C. 1510.
The Code of Federal Regulations is sold by the Superintendent of Documents.
Prices of new books are listed in the first FEDERAL REGISTER issue of each
week.
========================================================================
Federal Register / Vol. 73, No. 133 / Thursday, July 10, 2008 / Rules
and Regulations
[[Page 39569]]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2008-0039; Directorate Identifier 2006-SW-13-AD;
Amendment 39-15596; AD 2008-14-01]
RIN 2120-AA64
Airworthiness Directives; Bell Helicopter Textron Canada Model
222, 222B, 222U, 230 and 430 Helicopters
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment adopts a new airworthiness directive (AD) for
Bell Helicopter Textron Canada (BHTC) Model 222, 222B, 222U, 230 and
430 helicopters that requires rewiring and testing the fuel valve
switch on each engine and testing the ignitor system. This amendment is
prompted by an in-flight incident in which a fuel valve switch failed,
causing the fuel valve to inadvertently close. The actions specified by
this AD are intended to prevent interruption of the fuel supply caused
by failure of the fuel switch, which could result in loss of engine
power and subsequent loss of control of the helicopter.
DATES: Effective August 14, 2008.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of August 14, 2008.
ADDRESSES: You may get the service information identified in this AD
from Bell Helicopter Textron Canada, 12,800 Rue de l'Avenir, Mirabel,
Quebec J7J1R4, telephone (450) 437-2862 or (800) 363-8023, fax (450)
433-0272.
Examining the Docket: You may examine the docket that contains this
AD, any comments, and other information on the Internet at http://www.regulations.gov, or at the Docket Operations office, West Building
Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington,
DC.
FOR FURTHER INFORMATION CONTACT: George Schwab, Aviation Safety
Engineer, FAA, Rotorcraft Directorate, Safety Management Group, Fort
Worth, Texas 76193-0110, telephone (817) 222-5114, fax (817) 222-5961.
SUPPLEMENTARY INFORMATION: A proposal to amend 14 CFR part 39 to
include an AD for the specified model helicopters was published in the
Federal Register on January 23, 2008 (73 FR 3889). That action proposed
to require, within 50 hours time-in-service (TIS), rewiring the
switches that control the operation of the No. 1 and No. 2 engines'
fuel valves, and testing the switches and the ignitor system.
Transport Canada, the airworthiness authority for Canada, notified
the FAA that an unsafe condition may exist on BHTC Model 222, 222B,
222U, 230 and 430 helicopters. Transport Canada advises of an
investigation into an incident involving a BHTC Model 222 helicopter,
in which the fuel shut-off switch, part number (P/N) 10648BH1-1, failed
during flight causing the fuel valve to close and the engine to shut
down. Review of the Service Difficulty Report database identified two
other incidents of switch failure.
Bell Helicopter Textron has issued the following technical
bulletins, all dated June 11, 2003, which specify rewiring the fuel
valve switch:
------------------------------------------------------------------------
Technical bulletin Helicopter models affected
------------------------------------------------------------------------
No. 222-03-171............................ Model 222 and 222B
helicopters.
No. 222U-03-96............................ Model 222U helicopters.
No. 230-03-35............................. Model 230 helicopters.
No. 430-03-33............................. Model 430 helicopters.
------------------------------------------------------------------------
Transport Canada classified these technical bulletins as mandatory
and issued AD No. CF-2006-03, dated February 28, 2006, to ensure the
continued airworthiness of these helicopters in Canada. That AD
requires compliance no later than May 3, 2006. This AD requires
compliance within 50 hours TIS.
These helicopter models are manufactured in Canada and are type
certificated for operation in the United States under the provisions of
14 CFR 21.29 and the applicable bilateral agreement. Pursuant to the
applicable bilateral agreement, Transport Canada has kept the FAA
informed of the situation described above. The FAA has examined the
findings of Transport Canada, reviewed all available information, and
determined that AD action is necessary for products of this type design
that are certificated for operation in the United States.
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were received on the
proposal or the FAA's determination of the cost to the public. The FAA
has determined that air safety and the public interest require the
adoption of the rule as proposed.
The FAA estimates that this AD will affect 165 helicopters of U.S.
registry, and the required actions will take approximately four work
hours per helicopter to rewire the 2 fuel valve switches, and test
those switches and the ignitor system, at an average labor rate of $80
per work hour. Based on these figures, we estimate the total cost
impact of the AD on U.S. operators to be $52,800 ($320 per helicopter).
Regulatory Findings
We have determined that this AD will not have federalism
implications under Executive Order 13132. This AD will not have a
substantial direct effect on the States, on the relationship between
the national Government and the States, or on the distribution of power
and responsibilities among the various levels of government.
For the reasons discussed above, I certify that the regulation:
1. Is not a ``significant regulatory action'' under Executive Order
12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies
and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
We prepared an economic evaluation of the estimated costs to comply
with this AD. See the AD docket to examine the economic evaluation.
[[Page 39570]]
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. Subtitle VII, Aviation Programs,
describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in
Subtitle VII, Part A, Subpart III, section 44701, ``General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
0
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0
2. Section 39.13 is amended by adding a new airworthiness directive to
read as follows:
2008-14-01 Bell Helicopter Textron Canada: Amendment 39-15596.
Docket No. FAA-2008-0039; Directorate Identifier 2006-SW-13-AD.
Applicability: The following model helicopters, certificated in
any category:
------------------------------------------------------------------------
Model No. Serial Nos.
------------------------------------------------------------------------
222....................................... 47006 through 47089.
222B...................................... 47131 through 47156.
222U...................................... 47501 through 47574.
230....................................... 23001 through 23038.
430....................................... 49001 through 49101.
------------------------------------------------------------------------
Compliance: Required within 50 hours time-in-service, unless
accomplished previously.
To prevent interruption of the fuel supply caused by failure of
the fuel switch, which could result in loss of engine power and
subsequent loss of control of the helicopter, accomplish the
following:
(a) Rewire the No. 1 and No. 2 engines' fuel valve switch, part
number 10648BH1-1, and test the fuel valve switches and the ignitor
system, in accordance with the Accomplishment Instructions in Bell
Helicopter Textron Technical Bulletin (TB) No. 222-03-171, Part 1,
applicable to Model 222 helicopters, serial number (S/N) 47006-
47038, and Part 2, applicable to Model 222 helicopters, S/N 47039-
47089, and Model 222B helicopters, S/N 47131-47156; TB No. 222U-03-
96, applicable to Model 222U helicopters; TB No. 230-03-35,
applicable to Model 230 helicopters; and TB No. 430-03-33,
applicable to Model 430 helicopters. All of the technical bulletins
are dated June 11, 2003.
(b) To request a different method of compliance or a different
compliance time for this AD, follow the procedures in 14 CFR 39.19.
Contact the Manager, Safety Management Group, ATTN: George Schwab,
Aviation Safety Engineer, Rotorcraft Directorate, FAA, Fort Worth,
Texas 76193-0110, telephone (817) 222-5114, fax (817) 222-5961, for
information about previously approved alternative methods of
compliance.
(c) The rewiring and testing shall be done in accordance with
the specified portions of Bell Helicopter Textron Technical Bulletin
No. 222-03-171, No. 222U-03-96, No. 230-03-35, and No. 430-03-33,
all dated June 11, 2003. The Director of the Federal Register
approved this incorporation by reference in accordance with 5 U.S.C.
552(a) and 1 CFR part 51. Copies may be obtained from Bell
Helicopter Textron Canada, 12,800 Rue de l'Avenir, Mirabel, Quebec
J7J1R4, telephone (450) 437-2862 or (800) 363-8023, fax (450) 433-
0272. Copies may be inspected at the FAA, Office of the Regional
Counsel, Southwest Region, 2601 Meacham Blvd., Room 663, Fort Worth,
Texas or at the National Archives and Records Administration (NARA).
For information on the availability of this material at NARA, call
202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.
(d) This amendment becomes effective on August 14, 2008.
Note: The subject of this AD is addressed in Transport Canada
(Canada) AD CF-2006-03, dated February 28, 2006.
Issued in Fort Worth, Texas, on June 12, 2008.
Lance T. Gant,
Acting Manager, Rotorcraft Directorate, Aircraft Certification Service.
[FR Doc. E8-14718 Filed 7-9-08; 8:45 am]
BILLING CODE 4910-13-P
Sources. Section 1 is written by AircraftDirectives from the record below and is a reading aid only. Section 2 is the United States Government's own text, reproduced without edit.
Federal Register: https://www.federalregister.gov/documents/2008/07/10/E8-14718/airworthiness-directives-bell-helicopter-textron-canada-model-222-222b-222u-230-and-430-helicopters
Official PDF: https://www.govinfo.gov/content/pkg/FR-2008-07-10/pdf/E8-14718.pdf
Packet generated 2026-08-18 08:17 UTC.
This packet is not an airworthiness determination and not legal or maintenance advice. AircraftDirectives reproduces official records and condenses their wording for easier reading. It does not decide, certify or imply whether any aircraft, engine, appliance or part is airworthy, compliant, affected by this directive, or eligible for return to service. No inspection, approval, or determination of any kind is performed or implied by this document.
Section 1 is a reading aid, not the rule. It is our own plain-language condensation, written to help a reader find the relevant directive quickly. It is NOT a substitute for the regulation, it may omit conditions, exceptions, compliance times, alternative methods of compliance (AMOCs) and applicability limits, and it has no legal force whatsoever. Only the official text governs. Where Section 1 and Section 2 differ in any respect, Section 2 - and the official source it was retrieved from - controls absolutely.
Responsibility remains with the owner/operator. Under 14 CFR §91.403 and §91.417 the owner or operator is responsible for maintaining airworthiness and for required records; under §39.7 no person may operate a product to which an airworthiness directive applies except in accordance with that directive. Determining applicability to a specific serial number and configuration, and performing or supervising any required action, is the responsibility of the owner/operator and appropriately certificated personnel.
Accuracy and currency. Section 2 was retrieved at the time stamped above and is reproduced without edit; Federal Register material is a work of the United States Government. Directives are amended, corrected and superseded over time, and this sheet is a snapshot, not a live record - it does not update after printing. Re-check the official sources before acting on it. This packet is provided without warranty of any kind, express or implied, including fitness for a particular purpose. We do not sell parts and have no commercial interest in any action a directive may require.