Airworthiness Directive

AD 2000-15-52 65 FR 77785 Active

Federal Aviation Administration · 14 CFR part 39

Requires a one-time inspection of the snap ring groove area of the mast.

FR document
00-31628
Amendment
39-12042
Published
2000-12-13
Effective
2000-12-28
Models covered
1

Last live check: 2026-10-04

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.
AD

2000-15-52

FR doc 00-31628 · 65 FR 77785

AD 2000-15-52Published 2000-12-13Effective 2000-12-28

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires a one-time inspection of the snap ring groove area of the mast.

Supersedes an earlier directive. See the official text.

Full official abstract

This document publishes in the Federal Register an amendment adopting superseding Airworthiness Directive (AD) 2000-15-52, which was sent previously to all known U.S. owners and operators of Bell Helicopter Textron, Inc. Model (BHTI) Model 204B, 205A, 205A-1, 205B, and 212 helicopters by individual letters. This AD reduces the retirement index number (RIN) life limit for the main rotor mast (mast); increases the RIN factor for masts and main rotor trunnions (trunnions); applies standard RIN factors for all external load lifts; and requires a one-time inspection of the snap ring groove area of the mast. This AD also establishes RIN factors for masts and trunnions that have been previously installed on military or restricted category helicopters and removes from service those masts that have been previously installed with a hub spring. This amendment is prompted by an occurrence of a cracked mast at a lower value than the established RIN life limit. The actions specified by this AD are intended to preclude the occurrence of fatigue cracks in the damper clamp splined area of a mast. A crack in the damper clamp splined area could result in failure of a mast or trunnion, separation of the main rotor system, and subsequent loss of control of the helicopter.

More directives for Bell 205 / 212

  1. AD 2024-16-19 Airworthiness Directives; Bell Textron Inc. Helicopters Effective 2024-11-08
  2. AD 2024-17-02 Airworthiness Directives; Bell Textron Inc. Helicopters Effective 2024-11-08
  3. AD 2024-19-17 Airworthiness Directives; Bell Textron Inc. and Various Restricted Categ... Effective 2024-10-11
  4. AD 2022-20-14 Airworthiness Directives; Bell Textron Inc., Helicopters and Various Res... Effective 2022-12-27
  5. AD 2022-22-12 Airworthiness Directives; Bell Textron Inc., Erickson 214 Holdings, LLC,... Effective 2022-11-22

All Bell 205 / 212 directives

Applies to 1 model in our index