Airworthiness Directive

AD 2004-15-15 69 FR 45566 Active

Federal Aviation Administration · 14 CFR part 39

Requires you to repetitively inspect the upper longeron and upper diagonal tube on the left hand side of the aft fuselage structure for cracks and contact the manufacturer for a repair scheme if cracks are found.

FR document
04-17119
Amendment
39-13749
Published
2004-07-30
Effective
2004-09-07
Models covered
1

Last live check: 2026-08-19

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.
AD

2004-15-15

FR doc 04-17119 · 69 FR 45566

AD 2004-15-15Published 2004-07-30Effective 2004-09-07

Supersedes 2002-19-10

Supersedence is read from the Federal Register text of the newer AD — the FAA publishes no structured field for it — and names only ADs held in our index.

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires you to repetitively inspect the upper longeron and upper diagonal tube on the left hand side of the aft fuselage structure for cracks and contact the manufacturer for a repair scheme if cracks are found.

Full official abstract

The FAA supersedes Airworthiness Directive (AD) 2002-19-10, which applies to certain Air Tractor, Inc. (Air Tractor) Models AT-402, AT-402A, AT-402B, AT-602, AT-802, and AT-802A airplanes. AD 2002-19-10 currently requires you to repetitively inspect the upper longeron and upper diagonal tube on the left hand side of the aft fuselage structure for cracks and contact the manufacturer for a repair scheme if cracks are found. This AD is the result of reports of the same cracks recently found on AT-500 series airplanes. The manufacturer has also issued new and revised service information that incorporates a modification to terminate the repetitive inspection requirements. Consequently, this AD retains the inspection actions required in AD 2002-19-10, adds certain AT-500 series airplanes to the applicability section, changes the compliance times, and incorporates new and revised manufacturer service information that contains a terminating action for the repetitive inspection requirement. We are issuing this AD to detect and correct cracks in the upper aft longeron, which could cause the fuselage to fail. Such failure could result in loss of control of the airplane.

More directives for Air Tractor AT-Series

  1. AD 2026-16-12 Airworthiness Directives; Air Tractor, Inc. Airplanes Effective 2026-08-31
  2. AD 2024-16-06 Airworthiness Directives; Air Tractor, Inc. Airplanes Effective 2024-09-04
  3. AD 2023-15-07 Airworthiness Directives; Air Tractor, Inc. Airplanes Effective 2023-08-09
  4. AD 2021-05-14 Airworthiness Directives; Air Tractor, Inc., Airplanes Effective 2021-04-29
  5. AD 2014-16-17 Airworthiness Directives; Air Tractor, Inc. Airplanes Effective 2014-09-29

All Air Tractor AT-Series directives

Applies to 1 model in our index