Airworthiness Directive

AD 2005-12-06 70 FR 34336 Active

Federal Aviation Administration · 14 CFR part 39

Requires replacing riveted-impulse coupling assemblies and snap-ring coupling assemblies, which are worn beyond limits, with serviceable riveted-impulse coupling assemblies or snap-ring impulse coupling assemblies.

FR document
05-11610
Amendment
39-14122
Published
2005-06-14
Effective
2005-07-19
Model coverage
1 model if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2005-12-06

FR doc 05-11610 · 70 FR 34336

AD 2005-12-06Published 2005-06-14Effective 2005-07-19

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires replacing riveted-impulse coupling assemblies and snap-ring coupling assemblies, which are worn beyond limits, with serviceable riveted-impulse coupling assemblies or snap-ring impulse coupling assemblies.

Supersedes an earlier directive. See the official text.

Why this AD
Results from data provided by the manufacturer that shows a need to reduce the inspection intervals for riveted-impulse coupling assemblies used on certain Lycoming engine models.
Applies to
Teledyne Continental Motors (Formerly Bendix) S-20, S-1200, D-2000, and D-3000 Series Magnetos
Bulletins it references
MSB645

This AD cites MSB645 — the actions in that bulletin are required by this AD, the controlling document. Read the bulletin.

Full official abstract

The FAA is superseding an existing airworthiness directive (AD) for Teledyne Continental Motors (TCM) (formerly Bendix) S-20, S- 1200, D-2000, and D-3000 series magnetos equipped with impulse coupling assemblies. That AD currently requires replacing riveted-impulse coupling assemblies and snap-ring coupling assemblies, which are worn beyond limits, with serviceable riveted-impulse coupling assemblies or snap-ring impulse coupling assemblies. This ad requires a reduced inspection interval for magnetos with riveted-impulse coupling assemblies installed on certain Lycoming engine models. This AD does not lower the inspection interval for magnetos with snap-ring impulse coupling assemblies. This AD also limits the applicability to certain Lycoming engine models. This AD results from data provided by the manufacturer that shows a need to reduce the inspection intervals for riveted-impulse coupling assemblies used on certain Lycoming engine models. We are issuing this AD to prevent failure of the magneto impulse coupling assembly and possible engine failure.

Applies if a named part is installed: 1 model in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with a TCM (Bendix) magneto whose part number is in TCM MSB645 Table 1 (impulse coupling) installed.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.