Airworthiness Directive

AD 2011-18-51 R1 76 FR 61255 Active

Federal Aviation Administration · 14 CFR part 39

Requires an inspection of the airplane records to determine if a Dixie Aerospace, LLC main shaft bearing, P/N 3108098-1WD, is installed in the engine, and if installed, removal of that bearing from service, before further flight.

FR document
2011-25481
Amendment
39-16813
Published
2011-10-04
Effective
2011-10-19
Models covered
1

Last live check: 2026-11-12

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2011-18-51 R1

FR doc 2011-25481 · 76 FR 61255

AD 2011-18-51 R1Published 2011-10-04Effective 2011-10-19

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires an inspection of the airplane records to determine if a Dixie Aerospace, LLC main shaft bearing, P/N 3108098- 1WD, is installed in the engine, and if installed, removal of that bearing from service, before further flight.

Why this AD
Prompted by the need to list the affected bearings by serial number (S/N) in the AD for clarification.
Applies to
Honeywell International Inc. TPE331 Model Turboprop Engines With Certain Dixie Aerospace, LLC Main Shaft Bearings · 1 model in our index, listed below
Full official abstract

We are revising an existing emergency airworthiness directive (AD) for all Honeywell International Inc. TPE331 model turboprop engines with a part manufacturer approval (PMA) replacement Dixie Aerospace, LLC main shaft bearing part number (P/N) 3108098-1WD, installed. That emergency AD was not published in the Federal Register, but was sent to all known U.S. owners and operators of these engines. That AD currently requires an inspection of the airplane records to determine if a Dixie Aerospace, LLC main shaft bearing, P/N 3108098- 1WD, is installed in the engine, and if installed, removal of that bearing from service, before further flight. This AD requires the same actions. This AD revision was prompted by the need to list the affected bearings by serial number (S/N) in the AD for clarification. We are issuing this AD to correct the unsafe condition on these products.

More directives for Honeywell TPE331

  1. AD 2018-22-01 Airworthiness Directives; Honeywell International Inc. Turboprop Engines Effective 2018-12-10
  2. AD 2018-17-15 Airworthiness Directives; Honeywell International Inc. Turboprop and Tur... Effective 2018-10-22
  3. AD 2018-13-05 Airworthiness Directives; Honeywell International Inc. Turboprop and Tur... Effective 2018-07-26
  4. AD 2018-02-14 Airworthiness Directives; Honeywell International Inc. Turboprop and Tur... Effective 2018-02-28
  5. AD 2016-21-07 Airworthiness Directives; Honeywell International Inc. Turboprop Engines Effective 2016-11-28

All Honeywell TPE331 directives

Applies to 1 model in our index

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.