Airworthiness Directive

AD 94-01-03 R2 60 FR 31075

Federal Aviation Administration · 14 CFR part 39

Requires replacing Bendix ignition coils and rotating magnets, regardless of total time in service (TIS), with improved TCM ignition coils, rotating magnets and marking magnetos to indicate compliance, except for the S- 1200…

FR document
95-14496
Amendment
39-9271
Published
1995-06-13
Effective
1995-06-28
Status
Not determined in this index
Model coverage
Not mapped in this index

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

94-01-03 R2

FR doc 95-14496 · 60 FR 31075

AD 94-01-03 R2Published 1995-06-13Effective 1995-06-28

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires replacing Bendix ignition coils and rotating magnets, regardless of total time in service (TIS), with improved TCM ignition coils, rotating magnets and marking magnetos to indicate compliance, except for the S- 1200 series magnetos on which the AD requires replacing only the ignition coils as that series magneto already incorporates rotating magnets with the improved TCM design.

Why this AD
Prompted by comments that request clarification of the compliance notes and by the request to install replacement serviceable PMA parts.
Applies to
Teledyne Continental Motors (Formerly Bendix) S-20, S-200, S-600, and S-1200 Series Magnetos · not mapped to a model page in our index
Federal Register abstract

Summary (Federal Register abstract). This is the abstract the FAA published with the rule. It is not the rule's legal applicability; the official rule states that, including any part, serial-number, configuration and exception conditions.

This amendment revises an existing airworthiness directive (AD), applicable to Teledyne Continental Motors (TCM) (formerly Bendix) S-20, S-200, S-600, and S-1200 series magnetos, that currently requires replacing Bendix ignition coils and rotating magnets, regardless of total time in service (TIS), with improved TCM ignition coils, rotating magnets and marking magnetos to indicate compliance, except for the S- 1200 series magnetos on which the AD requires replacing only the ignition coils as that series magneto already incorporates rotating magnets with the improved TCM design. This amendment removes several notes after the applicability paragraph and inserts these as paragraphs into the applicability itself and into the compliance section to clarify that these actions are mandatory. In addition, this amendment allows installation of replacement serviceable Parts Manufacturer Approval (PMA) parts in addition to TCM parts. Also, this amendment clarifies that Bendix magnetos replaced with Slick magnetos satisfy the requirements of the AD, and that operators must perform the requirements of the AD on magnetos with Bendix magneto data plates that have been replaced with an overhaul facility's data plate. This amendment is prompted by comments that request clarification of the compliance notes and by the request to install replacement serviceable PMA parts. The actions specified by this AD are intended to prevent magneto failure and subsequent engine failure.

Model coverage: not mapped in this index

This record is listed from the Federal Register. We have not mapped it to any aircraft or engine model page, so no model page lists it. Check the official rule for exactly which products it applies to.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.