Airworthiness Directive

AD 2002-12-07 67 FR 41315 Active

Federal Aviation Administration · 14 CFR part 39

Requires the same replacements and inspection, and introduces the installation of an improved design gasket or converter plate kit as terminating action for the repetitive gasket replacements.

FR document
02-14696
Amendment
39-12779
Published
2002-06-18
Effective
2002-07-03
Model coverage
4 models if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2002-12-07

FR doc 02-14696 · 67 FR 41315

AD 2002-12-07Published 2002-06-18Effective 2002-07-03

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires the same replacements and inspection, and introduces the installation of an improved design gasket or converter plate kit as terminating action for the repetitive gasket replacements.

Supersedes an earlier directive that is not in our index. See the official text.

Compliance
Repetitive inspection or action, per the Federal Register abstract. The official rule sets the intervals.
Applies to
Textron Lycoming Reciprocating Engines
Full official abstract

This amendment supersedes emergency airworthiness directive (AD) 2000-18-53 that was sent previously to all known U.S. owners and operators of certain Textron Lycoming reciprocating engines. That action required before further flight after receipt of that emergency AD, replacement of the oil filter converter plate gasket or the converter plate kit. That action also required, within 10 hours time- in-service (TIS) or within 3 days after the effective date of that emergency AD, inspection of the oil filter base for signs of oil leakage and evidence of gasket extrusion. That action also required replacement of the converter plate gasket at intervals not to exceed 50 hours TIS since the last replacement of the gasket. This amendment requires the same replacements and inspection, and introduces the installation of an improved design gasket or converter plate kit as terminating action for the repetitive gasket replacements. The actions specified in this AD are intended to prevent complete loss of engine oil and subsequent seizing of the engine and possibility of fire, caused by oil leakage between the converter plate and accessory housing.

Applies if a named part is installed: 4 models in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with an oil filter converter plate gasket from the affected period installed: engines shipped Apr 1999 to Oct 2000, or since rebuilt, overhauled or given kit P/N LW-13904 or gasket P/N LW13388.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.