Airworthiness Directive

AD 2002-26-02 68 FR 35 Active

Federal Aviation Administration · 14 CFR part 39

Requires you to repetitively inspect the wing center section for evidence of corrosion through the installation of inspection openings, through the use of a specified scope and light source, or through the removal of the outer wing panels.

FR document
02-32885
Amendment
39-12987
Published
2003-01-02
Effective
2003-02-14
Models covered
1

Last live check: 2026-08-19

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.
AD

2002-26-02

FR doc 02-32885 · 68 FR 35

AD 2002-26-02Published 2003-01-02Effective 2003-02-14

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires you to repetitively inspect the wing center section for evidence of corrosion through the installation of inspection openings, through the use of a specified scope and light source, or through the removal of the outer wing panels.

Full official abstract

This amendment adopts a new airworthiness directive (AD) that applies to all Univair Aircraft Corporation (Univair) Models Alon A-2 and A2-A; ERCO 415-C, 415-CD, 415-D, 415-E, and 415-G; Forney F-1 and F-1A, and Mooney M10 airplanes. This AD requires you to repetitively inspect the wing center section for evidence of corrosion through the installation of inspection openings, through the use of a specified scope and light source, or through the removal of the outer wing panels. This AD also requires you to repair or replace any parts where corrosion or corrosion damage is found, install cover plates if inspection openings were made, and send inspection results to Federal Aviation Administration (FAA). This AD is the result of several reports of corrosion being found throughout the wing center section structure. The actions specified by this AD are intended to detect and correct corrosion in the wing center section which could result in failure of the wing center section structure during flight. Such failure could lead to loss of control of the airplane.

More directives for ERCO/Forney/Alon Ercoupe 415

  1. AD 2012-08-06 Airworthiness Directives; Univair Aircraft Corporation Airplanes Effective 2012-10-03
  2. AD 2003-21-01 Airworthiness Directives; Univair Aircraft Corporation Models Alon A-2 a... Effective 2003-12-01
  3. AD 2002-16-04 Airworthiness Directives; Univair Aircraft Corporation Models (ERCO) 415... Effective 2002-09-13
  4. AD 94-18-04 R1 Airworthiness Directives; Univair Aircraft Corporation Models Ercoupe 41... Effective 1995-03-24

All ERCO/Forney/Alon Ercoupe 415 directives

Applies to 1 model in our index