Airworthiness Directive

AD 2003-14-03 68 FR 41055 Active

Federal Aviation Administration · 14 CFR part 39

Requires initial and follow-up torque check inspections of pump relief valve attaching screws.

FR document
03-17019
Amendment
39-13222
Published
2003-07-10
Effective
2003-08-14
Model coverage
5 models if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2003-14-03

FR doc 03-17019 · 68 FR 41055

AD 2003-14-03Published 2003-07-10Effective 2003-08-14

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires initial and follow-up torque check inspections of pump relief valve attaching screws.

Supersedes an earlier directive that is not in our index. See the official text.

Why this AD
Prompted by the introduction of a new design pump relief valve housing and associated parts that provide enhanced resistance to fuel leakage, and the need for clarification of the requirements of the current AD.
Applies to
Textron Lycoming Fuel Injected Reciprocating Engines
Full official abstract

This amendment supersedes an existing airworthiness directive (AD), that is applicable to certain Textron Lycoming reciprocating engines with certain Crane/Lear Romec "AN" rotary fuel pumps installed. That AD currently requires initial and follow-up torque check inspections of pump relief valve attaching screws. This amendment requires the same initial and follow-up torque check inspections of relief valve attaching screws, and adds as a terminating action, replacement of the affected fuel pump at or before the overhaul interval, with a fuel pump having a new design valve housing. This amendment is prompted by the introduction of a new design pump relief valve housing and associated parts that provide enhanced resistance to fuel leakage, and the need for clarification of the requirements of the current AD. The actions specified by this AD are intended to prevent rotary fuel pump leaks, which could result in an engine failure, engine fire, and damage to or loss of aircraft.

Applies if a named part is installed: 5 models in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with a Crane/Lear Romec RG9080, RG9570 or RG17980 series rotary fuel pump listed in the AD installed.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.