Airworthiness Directive

AD 2012-03-07 77 FR 9837 Active

Federal Aviation Administration · 14 CFR part 39

Requires removing certain "machined-from-billet" Volare LLC (formerly Precision Airmotive Corporation, formerly Facet Aerospace Products Company, formerly Marvel-Schebler (BorgWarner)) HA-6 carburetors, inspecting for a loose…

FR document
2012-3862
Amendment
39-16948
Published
2012-02-21
Effective
2012-03-27
Model coverage
5 models if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2012-03-07

FR doc 2012-3862 · 77 FR 9837

AD 2012-03-07Published 2012-02-21Effective 2012-03-27

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires removing certain "machined-from-billet" Volare LLC (formerly Precision Airmotive Corporation, formerly Facet Aerospace Products Company, formerly Marvel-Schebler (BorgWarner)) HA-6 carburetors, inspecting for a loose mixture control sleeve or for a sleeve that may become loose, repairing the carburetor, or replacing the carburetor with one eligible for installation.

Why this AD
Prompted by a report of a "machined-from-billet" HA-6 carburetor having a loose mixture control sleeve that rotated in the carburetor body causing restriction of fuel and power loss.
Applies to
Lycoming Engines Reciprocating Engines
Full official abstract

We are adopting a new airworthiness directive (AD) for certain Lycoming Engines reciprocating engines. This AD was prompted by a report of a "machined-from-billet" HA-6 carburetor having a loose mixture control sleeve that rotated in the carburetor body causing restriction of fuel and power loss. This AD requires removing certain "machined-from-billet" Volare LLC (formerly Precision Airmotive Corporation, formerly Facet Aerospace Products Company, formerly Marvel-Schebler (BorgWarner)) HA-6 carburetors, inspecting for a loose mixture control sleeve or for a sleeve that may become loose, repairing the carburetor, or replacing the carburetor with one eligible for installation. We are issuing this AD to prevent engine in-flight shutdown, power loss, and reduced control of the airplane.

Applies if a named part is installed: 5 models in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with a "machined-from-billet" HA-6 carburetor of a part number listed in the AD installed.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.