Airworthiness Directive

AD 2016-16-12 81 FR 52975 Active

Federal Aviation Administration · 14 CFR part 39

Requires removal of the affected cylinder assemblies, including overhauled cylinder assemblies, according to a phased removal schedule.

FR document
2016-18708
Amendment
39-18610
Published
2016-08-11
Effective
2016-09-15
Model coverage
3 models if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2016-16-12

FR doc 2016-18708 · 81 FR 52975

AD 2016-16-12Published 2016-08-11Effective 2016-09-15

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires removal of the affected cylinder assemblies, including overhauled cylinder assemblies, according to a phased removal schedule.

Why this AD
Prompted by reports of multiple cylinder head-to-barrel separations and cracked and leaking aluminum cylinder heads.
Applies to
Continental Motors, Inc. Reciprocating Engines
Full official abstract

We are adopting a new airworthiness directive (AD) for certain Continental Motors, Inc., (CMI) San Antonio (formerly known as Airmotive Engineering Corp. (AEC)), replacement parts manufacturer approval (PMA) cylinder assemblies marketed by Engine Components International Division (ECi). On July 17, 2015, AEC was purchased by CMI and is now operating as "Continental Motors--San Antonio." These cylinder assemblies are used on all CMI model -520 and -550 reciprocating engines, and on all other CMI engine models approved for the use of model -520 and -550 cylinder assemblies, such as the CMI model -470 when modified by supplemental type certificate (STC). This AD was prompted by reports of multiple cylinder head-to-barrel separations and cracked and leaking aluminum cylinder heads. This AD requires removal of the affected cylinder assemblies, including overhauled cylinder assemblies, according to a phased removal schedule. We are issuing this AD to prevent failure of the cylinder assemblies, which could lead to failure of the engine, in-flight shutdown, and loss of control of the airplane.

Applies if a named part is installed: 3 models in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with ECi (Airmotive Engineering) PMA cylinder assemblies P/N AEC 631397, serial numbers 1 through 61176, installed.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.