Airworthiness Directive

AD 96-09-10 61 FR 29271 Active

Federal Aviation Administration · 14 CFR part 39

Requires replacement of sintered iron impellers in oil pumps.

FR document
96-14223
Amendment
39-9586
Published
1996-06-10
Effective
1996-07-15
Model coverage
4 models if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

96-09-10

FR doc 96-14223 · 61 FR 29271

AD 96-09-10Published 1996-06-10Effective 1996-07-15

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires replacement of sintered iron impellers in oil pumps.

Supersedes an earlier directive that is not in our index. See the official text.

Why this AD
Prompted by reports of additional oil pump failures caused by aluminum impellers, which do not have the reliability of the hardened steel impellers.
Applies to
Textron Lycoming Reciprocating Engines
Full official abstract

This amendment supersedes an existing airworthiness directive (AD), applicable to certain Textron Lycoming reciprocating engines, that currently requires replacement of sintered iron impellers in oil pumps. This amendment continues to require replacement of sintered iron impellers, but also requires replacement of aluminum impellers. This amendment is prompted by reports of additional oil pump failures caused by aluminum impellers, which do not have the reliability of the hardened steel impellers. The actions specified by this AD are intended to prevent an oil pump failure due to impeller failure, which could result in an engine failure.

Applies if a named part is installed: 4 models in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with an oil pump fitted with a sintered iron or aluminum impeller; the AD lists excepted models.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.