Airworthiness Directive

AD 97-04-12 62 FR 9068 Active

Federal Aviation Administration · 14 CFR part 39

Requires a one-time visual inspection of compressor bleed-off valves (BOVs) to determine if an affected supplier's code number is on the cover; and, if so, this AD requires the removal of the bleed valve cover assembly from the…

FR document
97-4993
Amendment
39-9936
Published
1997-02-27
Effective
1997-03-14
Model coverage
1 model if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

97-04-12

FR doc 97-4993 · 62 FR 9068

AD 97-04-12Published 1997-02-27Effective 1997-03-14

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires a one-time visual inspection of compressor bleed-off valves (BOVs) to determine if an affected supplier's code number is on the cover; and, if so, this AD requires the removal of the bleed valve cover assembly from the compressor bleed valve housing assembly and inspection of the cotter pin and the guide shaft pin.

Why this AD
Prompted by reports of two malfunctions of compressor BOVs that resulted in inflight engine power reduction.
Applies to
Pratt & Whitney Canada PT6 Series Turboprop Engines
Full official abstract

This amendment adopts a new airworthiness directive (AD) that is applicable to certain Pratt & Whitney Canada (PWC) PT6 series turboprop engines. This action requires a one-time visual inspection of compressor bleed-off valves (BOVs) to determine if an affected supplier's code number is on the cover; and, if so, this AD requires the removal of the bleed valve cover assembly from the compressor bleed valve housing assembly and inspection of the cotter pin and the guide shaft pin. If the cotter pin or guide shaft pin is not acceptable, this AD requires modifying the compressor BOV or replacing it with a serviceable part. This amendment is prompted by reports of two malfunctions of compressor BOVs that resulted in inflight engine power reduction. The actions specified in this AD are intended to prevent engine power reduction due to malfunction of the compressor BOV, which could result in a forced landing and loss of the aircraft.

Applies if a named part is installed: 1 model in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with a compressor bleed-off valve from the affected supplier installed (engine built, or valve changed, after Jan 1, 1995), in a single-engine aircraft; supplier code in the AD.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.