Airworthiness Directive

AD 97-26-16 62 FR 66508 Active

Federal Aviation Administration · 14 CFR part 39

Requires repetitively inspecting the engine mount beams for cracks on certain Cessna Aircraft Company (Cessna) Models 402C and 414A airplanes, and replacing any cracked beams.

FR document
97-32993
Published
1997-12-19
Effective
1998-02-02
Models covered
2

Last live check: 2026-11-14

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

97-26-16

FR doc 97-32993 · 62 FR 66508

AD 97-26-16Published 1997-12-19Effective 1998-02-02

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires repetitively inspecting the engine mount beams for cracks on certain Cessna Aircraft Company (Cessna) Models 402C and 414A airplanes, and replacing any cracked beams.

Supersedes an earlier directive that is not in our index. See the official text.

Why this AD
Results from the Federal Aviation Administration's policy on aging commuter-class aircraft, which is to eliminate or, in certain instances, reduce the number of certain repetitive short-interval inspections when improved parts or modifications are available.
Compliance
Repetitive inspection or action, per the Federal Register abstract. The official rule sets the intervals.
Applies to
Cessna Aircraft Company Models 402C and 414A Airplanes · 2 models in our index, listed below
Full official abstract

This amendment supersedes Airworthiness Directive (AD) 85-13- 03 R2, which currently requires repetitively inspecting the engine mount beams for cracks on certain Cessna Aircraft Company (Cessna) Models 402C and 414A airplanes, and replacing any cracked beams. This AD requires incorporating engine mount kits that will eliminate the need for the repetitive inspection requirement of AD 85-13-03 R2. This AD results from the Federal Aviation Administration's policy on aging commuter-class aircraft, which is to eliminate or, in certain instances, reduce the number of certain repetitive short-interval inspections when improved parts or modifications are available. The actions specified by this AD are intended to prevent failure of the engine mount beam caused by fatigue cracks, which could result in loss of the engine with consequent loss of the airplane.

More directives for Cessna 401/402

  1. AD 2018-03-03 R1 Airworthiness Directives; Textron Aviation Inc. Airplanes Effective 2018-05-23
  2. AD 2018-03-03 Airworthiness Directives; Textron Aviation Inc. Airplanes Effective 2018-02-28
  3. AD 2017-10-09 Airworthiness Directives; Textron Aviation Inc. Airplanes Effective 2017-06-07
  4. AD 2016-17-08 Airworthiness Directives; Textron Aviation, Inc. Airplanes Effective 2016-09-12
  5. AD 2016-07-24 Airworthiness Directives; Textron Aviation, Inc. Airplanes Effective 2016-04-26

All Cessna 401/402 directives

Applies to 2 models in our index

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.