Airworthiness Directive

AD 99-19-01 64 FR 49961 Active

Federal Aviation Administration · 14 CFR part 39

Requires a one-time visual and ultrasonic (UT) inspection of the No. 2 and No. 5 crankshaft cheeks for cracks.

FR document
99-23125
Published
1999-09-15
Effective
1999-09-30
Models covered
3

Last live check: 2026-11-13

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

99-19-01

FR doc 99-23125 · 64 FR 49961

AD 99-19-01Published 1999-09-15Effective 1999-09-30

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires a one-time visual and ultrasonic (UT) inspection of the No. 2 and No. 5 crankshaft cheeks for cracks.

Supersedes an earlier directive that is not in our index. See the official text.

Why this AD
Prompted by inspection results from the current priority letter AD.
Applies to
Teledyne Continental Motors O-470, IO- 470, TSIO-470, IO-520, TSIO-520, LTSIO-520, GTSIO-520, IO-550, TSIO- 550, and TSIOL-550 Series Reciprocating Engines · 3 models in our index, listed below
Full official abstract

This amendment adopts a new airworthiness directive (AD) that is applicable to Teledyne Continental Motors (TCM) O-470, IO-470, TSIO- 470, IO-520, TSIO-520, LTSIO-520, GTSIO-520, IO-550, TSIO-550, and TSIOL-550 series reciprocating engines. This action supersedes priority letter AD 99-09-17 that currently requires a one-time visual and ultrasonic (UT) inspection of the No. 2 and No. 5 crankshaft cheeks for cracks. All crankshafts found with a cracked cheek must be replaced with a serviceable crankshaft prior to further flight. This action adds to the applicability TCM GTSIO-520 series engines and additional engines, identified by serial numbers (S/Ns), of currently affected engine series; references a revised service bulletin that clarifies snap ring installation; increases to 500 hours time-in-service (TIS) the cutoff for engines that require a more immediate inspection; and corrects the contact telephone number for TCM. This amendment is prompted by inspection results from the current priority letter AD. The actions specified by this AD are intended to prevent crankshaft failure due to crankshaft cheek cracks, which could result in total engine power loss, in-flight engine failure, and possible forced landing.

More directives for Continental IO-520

  1. AD 2023-17-04 Airworthiness Directives; Continental Aerospace Technologies, Inc. Engin... Effective 2023-10-26
  2. AD 2023-05-16 Airworthiness Directives; Continental Aerospace Technologies, Inc., Reci... Effective 2023-03-15
  3. AD 2023-04-08 Airworthiness Directives; Continental Aerospace Technologies, Inc. Recip... Effective 2023-02-23
  4. AD 2023-02-12 Airworthiness Directives; Continental Aerospace Technologies, Inc. Recip... Effective 2023-02-17
  5. AD 2022-16-03 Airworthiness Directives; Continental Aerospace Technologies, Inc., Lyco... Effective 2022-08-15

All Continental IO-520 directives

Applies to 3 models in our index

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.