Airworthiness Directive

AD 2003-12-05 68 FR 35155 Superseded

Federal Aviation Administration · 14 CFR part 39

Requires an initial inspection for cracks in the propeller hub in accordance with a dye penetrant inspection procedure, replacement of propellers with cracks that do not meet acceptable limits, rework of propellers with cracks…

FR document
03-14675
Amendment
39-13190
Published
2003-06-12
Effective
2003-07-17
Model coverage
1 model if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2003-12-05

FR doc 03-14675 · 68 FR 35155

AD 2003-12-05Published 2003-06-12Effective 2003-07-17

Superseded by 2010-04-05

Supersedence is read from the Federal Register text of the newer AD — the FAA publishes no structured field for it — and names only ADs held in our index.

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires an initial inspection for cracks in the propeller hub in accordance with a dye penetrant inspection procedure, replacement of propellers with cracks that do not meet acceptable limits, rework of propellers with cracks that meet acceptable limits, and repetitive inspections of all affected propellers.

Supersedes an earlier directive that is not in our index. See the official text.

Why this AD
Prompted by the need to clarify the requirement to use a steel backing plate and Mylar gasket during installation of the propeller, and to relax the replacement requirements.
Compliance
Repetitive inspection or action, per the Federal Register abstract. The official rule sets the intervals.
Applies to
McCauley Propeller Systems 1A103/TCM Series Propellers
Superseded by
2010-04-05
Full official abstract

This amendment supersedes an existing airworthiness directive (AD), that is applicable to McCauley Propeller Systems 1A103/TCM series propellers. That AD currently requires an initial inspection for cracks in the propeller hub in accordance with a dye penetrant inspection procedure, replacement of propellers with cracks that do not meet acceptable limits, rework of propellers with cracks that meet acceptable limits, and repetitive inspections of all affected propellers. This amendment allows additional rework operations to be performed at more than one bolt hole location. This amendment is prompted by the need to clarify the requirement to use a steel backing plate and Mylar gasket during installation of the propeller, and to relax the replacement requirements. The actions specified in the proposed AD are intended to prevent propeller separation due to hub fatigue cracking, which can result in loss of control of the airplane.

Applies if a named part is installed: 1 model in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with a McCauley 1A103/TCM propeller with a serial number in the AD's ranges installed.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.