Airworthiness Directive

AD 2006-18-15 71 FR 52994 Superseded

Federal Aviation Administration · 14 CFR part 39

Requires initial and repetitive eddy current inspections (ECI) of the front cylinder half of the propeller hub for cracks and removing cracked hubs from service before further flight.

FR document
E6-14691
Amendment
39-14754
Published
2006-09-08
Effective
2006-09-25
Model coverage
1 model if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2006-18-15

FR doc E6-14691 · 71 FR 52994

AD 2006-18-15Published 2006-09-08Effective 2006-09-25

Superseded by 2009-22-03

Supersedence is read from the Federal Register text of the newer AD — the FAA publishes no structured field for it — and names only ADs held in our index.

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires initial and repetitive eddy current inspections (ECI) of the front cylinder half of the propeller hub for cracks and removing cracked hubs from service before further flight.

Why this AD
Results from a report of a propeller blade separating from a propeller hub.
Compliance
Repetitive inspection or action, per the Federal Register abstract. The official rule sets the intervals.
Applies to
Hartzell Propeller Inc. ( )HC-( )2Y( )-( ) Series Propellers
Superseded by
2009-22-03
Full official abstract

The FAA is adopting a new airworthiness directive (AD) for Hartzell Propeller Inc. ( )HC-( )2Y( )-( ) series propellers with non- suffix serial number (SN) propeller hubs installed on Lycoming O-, IO-, LO-, and AEIO-360 series reciprocating engines. This AD requires initial and repetitive eddy current inspections (ECI) of the front cylinder half of the propeller hub for cracks and removing cracked hubs from service before further flight. In addition, this AD allows installation of an improved design propeller hub (suffix SN "A" or "B") as terminating action to the repetitive ECI. This AD results from a report of a propeller blade separating from a propeller hub. We are issuing this AD to prevent failure of the propeller hub causing blade separation and subsequent loss of airplane control.

Applies if a named part is installed: 1 model in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with a Hartzell ( )HC-( )2Y( )-( ) propeller that has a non-suffix serial number hub installed.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.