Airworthiness Directive

AD 2009-22-03 74 FR 55130 Active

Federal Aviation Administration · 14 CFR part 39

Requires initial and repetitive eddy current inspections (ECIs) of the front cylinder half of the propeller hub for cracks and removing cracked hubs from service before further flight.

FR document
E9-25290
Amendment
39-16054
Published
2009-10-27
Effective
2009-11-12
Model coverage
1 model if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2009-22-03

FR doc E9-25290 · 74 FR 55130

AD 2009-22-03Published 2009-10-27Effective 2009-11-12

Supersedes 2006-18-15

Supersedence is read from the Federal Register text of the newer AD — the FAA publishes no structured field for it — and names only ADs held in our index.

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires initial and repetitive eddy current inspections (ECIs) of the front cylinder half of the propeller hub for cracks and removing cracked hubs from service before further flight.

Why this AD
Results from the need to make changes to the affected series designation of propellers, to expand the engine applicability, and to respond to comments received on AD 2006-18-15.
Compliance
Repetitive inspection or action, per the Federal Register abstract. The official rule sets the intervals.
Applies to
Hartzell Propeller Inc. ()HC-()2Y(K,R)-() Series Propellers
Supersedes
2006-18-15
Full official abstract

The FAA is superseding an existing airworthiness directive (AD) for Hartzell Propeller Inc. ()HC-()2Y()-() series propellers with non-suffix serial number (SN) propeller hubs installed on Lycoming O-, IO-, LO-, and AEIO-360 series reciprocating engines. That AD currently requires initial and repetitive eddy current inspections (ECIs) of the front cylinder half of the propeller hub for cracks and removing cracked hubs from service before further flight. In addition, that AD allows installation of an improved design propeller hub (suffix SN "A" or "B") as terminating action to the repetitive ECI. This ad requires the same actions but changes the affected propeller series designation to ()HC-()2Y(K,R)-() series propellers with non-suffix SN propeller hubs and suffix SN letter "E" propeller hubs. This AD also expands the engine eligibility to include Lycoming LIO-, TO-, LTO-, AIO-, and TIO-360-series engines. This AD results from the need to make changes to the affected series designation of propellers, to expand the engine applicability, and to respond to comments received on AD 2006- 18-15. We are issuing this AD to prevent failure of the propeller hub causing blade separation and subsequent loss of airplane control.

Applies if a named part is installed: 1 model in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with a Hartzell ( )HC-( )2Y(K,R)-( ) propeller that has a non-suffix or E-suffix serial number hub installed.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.