Airworthiness Directive

AD 2008-14-07 73 FR 39574 Superseded

Federal Aviation Administration · 14 CFR part 39

Requires inspection, and replacement if necessary, of externally mounted fuel injector fuel lines.

FR document
E8-14734
Amendment
39-15602
Published
2008-07-10
Effective
2008-08-14
Model coverage
4 models if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2008-14-07

FR doc E8-14734 · 73 FR 39574

AD 2008-14-07Published 2008-07-10Effective 2008-08-14

Superseded by 2011-26-04 Supersedes 2002-26-01

Supersedence is read from the Federal Register text of the newer AD — the FAA publishes no structured field for it — and names only ADs held in our index.

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires inspection, and replacement if necessary, of externally mounted fuel injector fuel lines.

Why this AD
Results from Lycoming Engines revising their Mandatory Service Bulletin to add new engine models requiring inspection, and from the need to clarify a repetitive inspection compliance time.
Compliance
Repetitive inspection or action, per the Federal Register abstract. The official rule sets the intervals.
Applies to
Lycoming Engines, Fuel Injected Reciprocating Engines
Supersedes
2002-26-01
Superseded by
2011-26-04
Full official abstract

The FAA is superseding an existing airworthiness directive (AD) for certain fuel injected reciprocating engines manufactured by Lycoming Engines. That AD currently requires inspection, and replacement if necessary, of externally mounted fuel injector fuel lines. This AD requires the same actions but adds additional engine models and clarifies certain compliance time wording. This AD also exempts engines that have a Maintenance and Overhaul Manual with an Airworthiness Limitations Section that requires inspection and replacement, if necessary, of externally mounted fuel injector lines. This AD results from Lycoming Engines revising their Mandatory Service Bulletin to add new engine models requiring inspection, and from the need to clarify a repetitive inspection compliance time. We are issuing this AD to prevent failure of the fuel injector fuel lines that would allow fuel to spray into the engine compartment, resulting in an engine fire.

Applies if a named part is installed: 4 models in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only fuel-injected engines with externally mounted fuel injector fuel lines (models in the AD's Table 1).

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.