Airworthiness Directive

AD 2011-26-04 76 FR 79051 Superseded

Federal Aviation Administration · 14 CFR part 39

Requires inspection, replacement if necessary, and proper clamping of externally mounted fuel injector fuel lines.

FR document
2011-32467
Amendment
39-16894
Published
2011-12-21
Effective
2012-01-25
Model coverage
4 models if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2011-26-04

FR doc 2011-32467 · 76 FR 79051

AD 2011-26-04Published 2011-12-21Effective 2012-01-25

Superseded by 2015-19-07 Supersedes 2008-14-07

Supersedence is read from the Federal Register text of the newer AD — the FAA publishes no structured field for it — and names only ADs held in our index.

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires inspection, replacement if necessary, and proper clamping of externally mounted fuel injector fuel lines.

Why this AD
Prompted by Lycoming Engines revising their Mandatory Service Bulletin (MSB) to add engine models requiring inspections.
Applies to
Lycoming Engines, Fuel Injected Reciprocating Engines
Supersedes
2008-14-07
Superseded by
2015-19-07
Full official abstract

We are superseding an existing airworthiness directive (AD) for certain fuel injected reciprocating engines manufactured by Lycoming Engines. That AD currently requires inspection, replacement if necessary, and proper clamping of externally mounted fuel injector fuel lines. That AD also states that it is not applicable to engines that have a Maintenance and Overhaul Manual with an Airworthiness Limitations Section that requires inspection and replacement, if necessary, of externally mounted fuel injector lines. This new AD requires the same actions. This AD was prompted by Lycoming Engines revising their Mandatory Service Bulletin (MSB) to add engine models requiring inspections. We are issuing this AD to prevent failure of the fuel injector fuel lines that would allow fuel to spray into the engine compartment, resulting in an engine fire.

Applies if a named part is installed: 4 models in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only fuel-injected engines with externally mounted fuel injector fuel lines (models in the AD's Table 1).

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.