Airworthiness Directive

AD 2008-19-05 73 FR 53105 Superseded

Federal Aviation Administration · 14 CFR part 39

Requires initial and repetitive visual inspections and compression tests to detect cracks at the head- to-barrel interface, replacement of cylinder assemblies found cracked, and replacement of certain cylinder assemblies, at new…

FR document
E8-21125
Amendment
39-15672
Published
2008-09-15
Effective
2008-10-20
Model coverage
3 models if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2008-19-05

FR doc E8-21125 · 73 FR 53105

AD 2008-19-05Published 2008-09-15Effective 2008-10-20

Superseded by 2009-26-12

Supersedence is read from the Federal Register text of the newer AD — the FAA publishes no structured field for it — and names only ADs held in our index.

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires initial and repetitive visual inspections and compression tests to detect cracks at the head- to-barrel interface, replacement of cylinder assemblies found cracked, and replacement of certain cylinder assemblies, at new reduced times- in-service.

Why this AD
Results from reports of 45 failures with head separations of ECi cylinder assemblies.
Compliance
Repetitive inspection or action, per the Federal Register abstract. The official rule sets the intervals.
Applies to
Engine Components, Inc. (ECi) Reciprocating Engine Cylinder Assemblies
Superseded by
2009-26-12
Full official abstract

The FAA is adopting a new airworthiness directive (AD) for Lycoming Engines (formerly Textron Lycoming) models 320, 360, and 540 series, "Parallel Valve" reciprocating engines, with certain Engine Components, Inc. (ECi) cylinder assemblies, part number (P/N) AEL65102 series "Titan", installed. This AD requires initial and repetitive visual inspections and compression tests to detect cracks at the head- to-barrel interface, replacement of cylinder assemblies found cracked, and replacement of certain cylinder assemblies, at new reduced times- in-service. This AD results from reports of 45 failures with head separations of ECi cylinder assemblies. We are issuing this AD to prevent loss of engine power due to cracks at the head-to-barrel interface in the cylinder assemblies and possible engine failure caused by separation of a cylinder head, which could result in loss of control of the aircraft.

Applies if a named part is installed: 3 models in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with ECi "Titan" cylinder assemblies P/N AEL65102 series with cylinder head P/N AEL85099 in the AD's serial number groups installed.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.