Airworthiness Directive

AD 2009-26-12 74 FR 69252 Active

Federal Aviation Administration · 14 CFR part 39

Requires initial and repetitive visual inspections and compression tests to detect cracks at the head-to-barrel interface, replacement of cylinder assemblies found cracked, and replacement of certain cylinder assemblies at new…

FR document
E9-30732
Amendment
39-16151
Published
2009-12-31
Effective
2010-02-04
Model coverage
3 models if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2009-26-12

FR doc E9-30732 · 74 FR 69252

AD 2009-26-12Published 2009-12-31Effective 2010-02-04

Supersedes 2008-19-05

Supersedence is read from the Federal Register text of the newer AD — the FAA publishes no structured field for it — and names only ADs held in our index.

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires initial and repetitive visual inspections and compression tests to detect cracks at the head-to-barrel interface, replacement of cylinder assemblies found cracked, and replacement of certain cylinder assemblies at new, reduced times-in-service.

Why this AD
Results from reports of 10 additional cylinder head separations since issuing AD 2008-19-05, on cylinder serial numbers not listed in that AD.
Compliance
Repetitive inspection or action, per the Federal Register abstract. The official rule sets the intervals.
Applies to
Engine Components, Inc. (ECi) Reciprocating Engine Cylinder Assemblies
Supersedes
2008-19-05
Full official abstract

The FAA is superseding an existing airworthiness directive (AD) for Lycoming Engines (formerly Textron Lycoming) models 320, 360, and 540 series, "Parallel Valve" reciprocating engines, with certain Engine Components, Inc. (ECi) cylinder assemblies, part number (P/N) AEL65102 series "Titan," installed. That AD currently requires initial and repetitive visual inspections and compression tests to detect cracks at the head-to-barrel interface, replacement of cylinder assemblies found cracked, and replacement of certain cylinder assemblies at new, reduced times-in-service. This AD requires the same actions, but for an expanded population of cylinder assemblies. This AD results from reports of 10 additional cylinder head separations since issuing AD 2008-19-05, on cylinder serial numbers not listed in that AD. We are issuing this AD to prevent loss of engine power due to cracks at the head-to-barrel interface and possible engine failure caused by separation of a cylinder head, which could result in loss of control of the aircraft.

Applies if a named part is installed: 3 models in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with ECi "Titan" cylinder assemblies P/N AEL65102 series with cylinder head P/N AEL85099 in the AD's serial number groups installed.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.