Airworthiness Directive

AD 2024-21-02 89 FR 86721 Superseded

Federal Aviation Administration · 14 CFR part 39

Requires repetitive oil inspections for bronze metal particulates and, if found, additional inspections of the connecting rod bushings for damage, proper fit, movement, and wear, and replacement if necessary.

FR document
2024-25365
Amendment
39-22869
Published
2024-10-31
Effective
2024-12-05
Model coverage
7 models if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2024-21-02

FR doc 2024-25365 · 89 FR 86721

AD 2024-21-02Published 2024-10-31Effective 2024-12-05

Superseded by 2026-04-11

Supersedence is read from the Federal Register text of the newer AD — the FAA publishes no structured field for it — and names only ADs held in our index.

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires repetitive oil inspections for bronze metal particulates and, if found, additional inspections of the connecting rod bushings for damage, proper fit, movement, and wear, and replacement if necessary.

Why this AD
Prompted by several reports of connecting rod failures, which resulted in uncontained engine failure and in-flight shutdowns (IFSDs).
Compliance
Repetitive inspection or action, per the Federal Register abstract. The official rule sets the intervals.
Applies to
Lycoming Engines
Superseded by
2026-04-11
Full official abstract

The FAA is adopting a new airworthiness directive (AD) for Lycoming Engines (Lycoming) model engines that have a certain connecting rod assemblies installed. This AD was prompted by several reports of connecting rod failures, which resulted in uncontained engine failure and in-flight shutdowns (IFSDs). This AD requires repetitive oil inspections for bronze metal particulates and, if found, additional inspections of the connecting rod bushings for damage, proper fit, movement, and wear, and replacement if necessary. As terminating action to the connecting rod bushing inspections, this AD requires replacement of the connecting rod bushings with parts eligible for installation. The FAA is issuing this AD to address the unsafe condition on these products.

Applies if a named part is installed: 7 models in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with a connecting rod or connecting rod bushing whose part number and ship date are in the AD's Table 1 installed.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.