Airworthiness Directives

An Airworthiness Directive is a legally enforceable FAA rule (14 CFR 39.3). This page is where you look one up by number, subject or aircraft, check the status our index records for it, and open the official Federal Register record. How we source and re-check every directive.

What these mean

Active - mapped directives our index has not marked as superseded or rescinded. Check the official rule for current status, applicability and compliance requirements. A directive that applies to a model only when a named part is installed counts as mapped.

Superseded - directives our index records as replaced by a later directive. Open the record to see which one, and check the official rules.

Rescinded - directives the FAA has withdrawn. They stay here so an old logbook entry can still be traced to its record.

Not determined - directives we hold from the Federal Register but have not mapped to any aircraft or engine model, so our index cannot tell whether a later directive has replaced them. Open the record and check the official rule for current status.

Corrections - Federal Register notices that fix an error in an existing directive. Each one attaches to the directive it corrects; none is a new rule.

Active counts mapped directives that have not been superseded or rescinded in our index. Not determined counts directives our index cannot place; they are never counted as active.

Newest active directives page 47 of 56

  1. ADAD 98-18-11Requires a visual inspection of the bond line between the main rotor blade abrasion strip (abrasion strip)…Schweizer Aircraft Corporation and Hughes Helicopters, Inc. Model 269A, 269A-1, 269B, 269C, 269D, and TH- 55A HelicoptersEffective 1998-10-07
  2. ADAD 98-17-03Requires replacing the propeller shaft, the bearings, and the front drive belt retaining rings with ones of…Glaser-Dirks Flugzeugbau GmbH Model DG- 400 GlidersEffective 1998-09-26
  3. ADAD 98-17-02Requires inspecting the tow release cable guide fittings for the correct mounting, and, if the fittings are…Alexander Schleicher Segelflugzeugbau Model ASW-19 SailplanesEffective 1998-09-26
  4. ADAD 98-19-01Requires replacing the O-ring that is installed in the mounting part of the pitot tube (in the propeller…Stemme GmbH & Co. KG Model S10 SailplanesEffective 1998-09-25
  5. ADAD 98-11-01 R1Requires replacing the fuel tank vent valves and drilling a 4.8 millimeter (0.1875 inch) hole in each fuel…Pilatus Aircraft Ltd. Models PC-12 and PC-12/45 AirplanesEffective 1998-09-22
  6. ADAD 98-16-16Requires replacing the seal unit on both main landing gear (MLG) legs and the nose landing gear (NLG) leg.Pilatus Aircraft Ltd. Model PC-7 AirplanesEffective 1998-09-21
  7. ADAD 98-16-15Requires installing an inspection opening in the area of the main spar web, repetitively inspecting the area…British Aerospace Model B.121 Series 1, 2, and 3 AirplanesEffective 1998-09-21
  8. ADAD 98-16-14Requires replacing the attachment bolts, nuts and washers of the lower fitting of the main landing gear…Pilatus Britten-Norman Ltd. BN-2, BN- 2A, BN-2B, and BN-2T Series AirplanesEffective 1998-09-21
  9. ADAD 98-16-04Requires inspecting between wing station (W.S.) 90 and W.S. 110 for an angle stiffener at the lower wing…Cessna Aircraft Company 180, 182, and 185 Series AirplanesEffective 1998-09-21
  10. ADAD 97-20-10 R1Requires modification of the attitude and heading reference systems (AHRS).de Havilland Model DHC-8-100, -200, and -300 Series AirplanesEffective 1998-09-11
  11. ADAD 98-12-31Requires repositioning the fuel cross feed pipes in the lower center fuselage to give an overall clearance…British Aerospace Jetstream Model 3101 AirplanesEffective 1998-09-10
  12. ADAD 98-15-20Requires inspecting the center of gravity (C.G.) tow release cable pulley for correct positioning, and…Glaser-Dirks Flugzeugbau GmbH Model DG- 500M GlidersEffective 1998-09-09
  13. ADAD 98-15-19Requires replacing certain flexible hoses in the engine oil system with flexible hoses with a larger…Aeromot-Industria Mecanico Metalurgica Ltda. Model AMT-200 Powered GlidersEffective 1998-09-07
  14. ADAD 98-14-07Requires modifying the lower forward doorpost bulkhead by installing rivets.Cessna Aircraft Company Model 172R AirplanesEffective 1998-08-16
  15. ADAD 98-15-16Requires installation of an improved fuel pump and fuel supply tube.Bombardier-Rotax GmbH 912 F Series Reciprocating EnginesEffective 1998-08-07
  16. ADAD 98-12-09Requires removal of suspect fuel manifold assemblies and replacement with serviceable assemblies.AlliedSignal Inc. Model TPE331 Series Turboprop EnginesEffective 1998-08-07
  17. ADAD 98-14-04Requires modification of the lever assembly of the roll disconnect system.de Havilland Model DHC-8-100, -200, and -300 Series AirplanesEffective 1998-08-05
  18. ADAD 98-13-11Requires modifying the airplane by incorporating Raytheon Kit No. 129-5200-1, ``Ground Fine Switch…Raytheon Aircraft Company Model 1900D AirplanesEffective 1998-08-03
  19. ADAD 98-13-06Requires replacing the bungees that secure the left engine restraining cable and the bowden cable of the…Glaser-Dirks Flugzeugbau GmbH Model DG- 400 GlidersEffective 1998-08-02
  20. ADAD 98-13-04Requires repetitively inspecting the airbrakes to assure they retract at their outboard end first, and…Glaser-Dirks Flugzeugbau GmbH Models DG-100 and DG-400 GlidersEffective 1998-08-02
  21. ADAD 98-13-09Requires marking the airspeed indicator to indicate the correct flap operation range and stall speed of the…AERMACCHI S.p.A. Models F.260, F.260B, F.260C, and F.260D AirplanesEffective 1998-08-01
  22. ADAD 98-13-07Requires accomplishing a leakage check of all lavatory water tube/hose connections, and correcting the…Industrie Aeronautiche e Meccaniche Model Piaggio P-180 Airplanes.Effective 1998-08-01
  23. ADAD 98-13-05Requires inspecting the main spar fitting for excessive tolerance, traces, movement, etc., and repairing the…Alexander Schleicher Segelflugzeugbau Model AS-K13 SailplanesEffective 1998-08-01
  24. ADAD 98-13-08Requires replacing and re-routing the power return cables on the starter generator and generator 2…Pilatus Aircraft Ltd. Model PC-12 AirplanesEffective 1998-07-31
  25. ADAD 98-13-38Requires installation of a warning placard for the fire extinguisher exhaust port located in the rear…British Aerospace (Jetstream) Model 4101 AirplanesEffective 1998-07-30
  26. ADAD 98-12-23Requires replacing the windshield wiper arm attachment bolts and windshield wiper arm on all of the affected…British Aerospace Model H.P. 137 Jetstream Mk. 1, Jetstream Model 3101, Jetstream Model 3201, and Jetstream 200 Series AirplanesEffective 1998-07-28
  27. ADAD 98-12-11Requires modifying the emergency hydraulic hand-pump by increasing the length of the access aperture.British Aerospace Jetstream Model 3101 AirplanesEffective 1998-07-24
  28. ADAD 98-12-04Requires installing a rudder gap seal and modifying the cooling liquid reservoir mount.Glaser-Dirks Flugzeugbau GmbH Model DG- 500M GlidersEffective 1998-07-21
  29. ADAD 98-13-41Requires correcting, repairing, or replacing any damaged or missing part, and reporting any of the above…Cessna Aircraft Company Model 172R AirplanesEffective 1998-07-20
  30. ADAD 98-12-14Requires inspecting the flap cable pulley bracket for correct alignment and correcting any misalignment…AERMACCHI S.p.A. S.205 Series and Models S.208 and S.208A AirplanesEffective 1998-07-18
  31. ADAD 98-12-13Industrie Aeronautiche e Meccaniche Model Piaggio P-180 AirplanesEffective 1998-07-18
  32. ADAD 98-12-06Requires replacing the fuel filter if it is contaminated, inserting a revision to the Limitations Section of…Stemme GmbH & Co. KG Models S10 and S10-V Sailplanes.Effective 1998-07-17
  33. ADAD 98-12-02Requires inspecting the elevator trim tab fittings for cracks, and replacing any elevator trim tab found to…SOCATA Groupe Aerospatiale Model TBM 700 AirplanesEffective 1998-07-17
  34. ADAD 98-11-31Requires modifying the autopilot elevator electric system relays by installing two additional relays and…British Aerospace Jetstream Model 3101 AirplanesEffective 1998-07-17
  35. ADAD 98-12-22Requires shimming the tail rotor drive system bearing supports (bearing supports).Bell Helicopter Textron Canada Model 407 HelicoptersEffective 1998-07-15
  36. ADAD 98-12-03This amendment adopts a new airworthiness directive (AD) that applies to certain Alexander Schleicher…Alexander Schleicher Segelflugzeugbau Models ASW-19 and ASK 21 SailplanesEffective 1998-07-14
  37. ADAD 98-11-20Requires modifying the lavatory wall and passenger seat configuration.Pilatus Aircraft Ltd. Models PC-12 and PC-12/45 AirplanesEffective 1998-07-13
  38. ADAD 98-11-16Requires modifying the logic in the failure detection circuits of the landing gear uplock switches.Dornier Luftfahrt GmbH Models 228-100, 228-101, 228-200, 228-201, 228-202, and 228-212 AirplanesEffective 1998-07-11
  39. ADAD 98-11-18Requires replacing the upper rubber shock mounts with mounts made of stainless steel.Glaser-Dirks Flugzeugbau GmbH Model DG- 400 GlidersEffective 1998-07-10
  40. ADAD 98-11-17Requires replacing the Bosch electrical system regulator, part number (P/N) 0212920001, with a type 4 E 26…Glaser-Dirks Flugzeugbau GmbH Model DG- 400 GlidersEffective 1998-07-10

Older directives by publication year: 2026 · 2025 · 2024 · 2023 · 2022 · 2021 · 2020 · 2019 · 2018 · 2017 · 2016 · 2015 · 2014 · 2013 · 2012 · 2011 · 2010 · 2009 · 2008 · 2007 · 2006 · 2005 · 2004 · 2003 · 2002 · 2001 · 2000 · 1999 · 1998 · 1997 · 1996 · 1995

Browse by make