Airworthiness Directive

AD 96-09-06 61 FR 18667 Active

Federal Aviation Administration · 14 CFR part 39

Requires repetitively inspecting (visually) the air filter frame for a loose or deteriorating gasket on airplanes incorporating certain Brackett air filter assemblies and replacing any gasket found loose or deteriorated.

FR document
96-10307
Amendment
39-9580
Published
1996-04-29
Effective
1996-06-07
Model coverage
18 models if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

96-09-06

FR doc 96-10307 · 61 FR 18667

AD 96-09-06Published 1996-04-29Effective 1996-06-07

Supersedes 95-03-02

Supersedence is read from the Federal Register text of the newer AD — the FAA publishes no structured field for it — and names only ADs held in our index.

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires repetitively inspecting (visually) the air filter frame for a loose or deteriorating gasket on airplanes incorporating certain Brackett air filter assemblies and replacing any gasket found loose or deteriorated.

Compliance
Repetitive inspection or action, per the Federal Register abstract. The official rule sets the intervals.
Applies to
Brackett Aircraft Company, Inc. Air Filter Assemblies Installed on Airplanes
Supersedes
95-03-02
Full official abstract

This document supersedes airworthiness directive (AD) 95-03- 02, which currently requires repetitively inspecting (visually) the air filter frame for a loose or deteriorating gasket on airplanes incorporating certain Brackett air filter assemblies and replacing any gasket found loose or deteriorated. This action requires retaining the repetitive inspection as contained in AD 95-03-02, and will incorporate additional Brackett air filter assemblies to the ``Applicability'' section of that AD. Additionally, this AD will provide a terminating action for the repetitive inspection. The Federal Aviation Administration's determination that certain additional Bracket air filter assemblies should be inspected and replaced prompted this AD action. The actions specified by this AD are intended to prevent gasket particles from entering the carburetor because of air filter gasket failure, which could result in partial or complete loss of engine power and loss of control of the airplane.

Applies if a named part is installed: 18 models in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with a Brackett air filter assembly (part number in the AD's chart) that uses a neoprene gasket installed.

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.