Cessna 170

Airworthiness Directives; Cessna Aircraft Company Models 150, 152, 170, 172, 175, 177, 180, 182, 185, 188, 190, 195, 206, 207, 210, T303, 336, and 337 Airplanes

We are superseding an existing airworthiness directive (AD) for Cessna Aircraft Company (Cessna) 150, 152, 170, 172, 175, 177, 180, 182, 185, 188, 190, 195, 206, 207, 210, T303, 336, and 337 series airplanes. That AD currently requires repetitive inspections and replacement of parts, if necessary, of the seat rail and seat rail holes; seat pin engagement; seat rollers, washers, and axle bolts or bushings; wall thickness of roller housing and the tang; and lock pin springs. This new AD requires retaining all of the actions from the previous AD and adding steps to the inspection procedures in the previous AD. This AD was prompted by added steps to the inspection procedures, added revised figures, and clarification of some of the existing steps. We are issuing this AD to prevent seat slippage or the seat roller housing from departing the seat rail, which may consequently cause the pilot/copilot to be unable to reach all the controls. This failure could lead to the pilot/copilot losing control of the airplane.

Airworthiness Directives; Cessna Aircraft Company 120, 140, 140A, 150, F150, 170, 172, F172, FR172, P172D, 175, 177, 180, 182, 185, A185E, 190, 195, 206, P206, U206, TP206, TU206, 207, T207, 210, T210, 336, 337, and T337 Series Airplanes

The FAA adopts a new airworthiness directive (AD) that will supersede AD 86-26-04, which applies to certain Cessna Aircraft Company (Cessna) 120, 140, 140A, 150, F150, 170, 172, F172, FR172, P172D, 175, 177, 180, 182, 185, A185E, 190, 195, 205, 205A, 206, P206, P206E, TP206A, TU206, TU206E, U206, U206E, 207, T207, 210, T210, 336, 337, and T337 series airplanes. AD 86-26-04 currently requires you to inspect and, if necessary, modify the pilot/co-pilot upper shoulder harness adjusters that have certain Cessna accessory kits incorporated. This AD is the result of reports that additional airplanes have the same unsafe condition and the manufacturer revised the service information to add these airplanes and correct the part number of the shoulder harness adjusters. Consequently, this AD retains the actions of 86-26-04, adds additional airplanes to the applicability section of this AD, and incorporates the revised service information. We are issuing this AD to prevent slippage of the pilot/co-pilot shoulder harness, which could result in failure of the shoulder harness to maintain proper belt length adjustment and tension. Such failure could result in pilot/co- pilot injury.

Airworthiness Directives; Cessna Aircraft Company 170, 172, 175, and 177 Series Airplanes

This amendment adopts a new airworthiness directive (AD) that applies to all Cessna Aircraft Company (Cessna) 170, 172, 175, and 177 series airplanes. This AD requires replacing certain fuel selector valve cams or fuel selector valves that Cessna shipped from December 6, 1998, through May 10, 1999, and prevents the future installation of these fuel selector valve cams or fuel selector valves. This AD allows the pilot to check the logbooks to determine whether one of these fuel selector valve cams or fuel selector valves is installed. This AD results from reports from Cessna that fuel selector valve cams and fuel selector valves were manufactured with control shafts that will not allow both tanks to supply fuel to the engine in certain situations. The actions specified by this AD are intended to prevent an inadequate supply of fuel from reaching the engine because of a fuel selector valve cam or fuel selector valve. This could result in an emergency landing or loss of control of the airplane.