Airworthiness Directive

AD 2023-09-09 88 FR 37975 Active

Federal Aviation Administration · 14 CFR part 39

Requires repetitively inspecting the spot-welded, multi- segment exhaust tailpipe v-band coupling.

FR document
2023-12417
Amendment
39-22432
Published
2023-06-12
Effective
2023-07-17
Model coverage
42 models if a part is installed

Last live check: 2026-11-15

This page is a reference Record, not an airworthiness or compliance determination. Read the full notice.

AD

2023-09-09

FR doc 2023-12417 · 88 FR 37975

AD 2023-09-09Published 2023-06-12Effective 2023-07-17

FAA rule - 14 CFR 39

FAA rule. Compliance with an applicable AD is required under 14 CFR 39.7. Check its effective date, applicability, compliance times and current status.

Requires repetitively inspecting the spot-welded, multi- segment exhaust tailpipe v-band coupling.

Why this AD
Prompted by multiple failures of spot-welded, multi-segment v-band couplings at the tailpipe to the turbocharger exhaust housing flange (also referred to as "spot-welded, multi- segment exhaust tailpipe v-band coupling").
Compliance
Repetitive inspection or action, per the Federal Register abstract. The official rule sets the intervals.
Applies to
Various Airplanes, Helicopters, and Engines
Full official abstract

The FAA is adopting a new airworthiness directive (AD) for turbocharged, reciprocating engine-powered airplanes and helicopters and turbocharged, reciprocating engines with a certain v-band coupling installed. This AD was prompted by multiple failures of spot-welded, multi-segment v-band couplings at the tailpipe to the turbocharger exhaust housing flange (also referred to as "spot-welded, multi- segment exhaust tailpipe v-band coupling"). This AD establishes a life limit for the spot-welded, multi-segment exhaust tailpipe v-band coupling and requires repetitively inspecting the spot-welded, multi- segment exhaust tailpipe v-band coupling. The FAA is issuing this AD to address the unsafe condition on these products.

Applies if a named part is installed: 42 models in our index

This directive names a part, appliance, propeller or supplemental type certificate rather than these models. It applies to one of them only when the affected item is installed; the official rule says which parts, serial numbers and dates.

Condition: Only with a spot-welded, multi-segment v-band coupling at the tailpipe-to-turbocharger flange (turbocharged installations).

This page is a reference Record, not an airworthiness or compliance determination. Official FAA and manufacturer sources control over our restatement, subject to governing law. Check applicability, current requirements and incorporated documents before acting. The owner or operator remains responsible for airworthiness and required records under 14 CFR 91.403 and 91.417, as applicable. Terms of Use: /terms.